How To Splice Lighting Wire

Place the stripped ends of each wire into a splice connector making sure to leave no bare metal exposed.

How to splice lighting wire. Then take off about half an inch of plastic coating leaving the ends of the wires exposed. To tap into an existing wire with a connector simply cut the cable where it needs to be spliced. Make sure each cut end is 1 inch bare and the internal wires can be easily operated on.

Stretch out the existing low voltage landscape lighting wire. Also make sure you keep them at least 5 inch apart from each other. Slide a piece of shrink tubing over the wire youre splicing as youll need it once you complete the splice.

Remove the insulation from the cut end of wires. Normally when we exte. If your junction box isnt already set up with clamps you may have to install some into the openings on.

Separate the leads on both wires for 4 to 6 inches from the ends you plan to splice and strip at least 1. For many people this is fine but if your yard is larger than the manufacturer assumes or you have creative ideas for where to place your light features those lengths can be insufficient and you may need to splice low-voltage landscape-lighting wire. Use a splice kit to join low-voltage outdoor wiring such as landscape lighting.

Crimping the ends holds the wires in place. Cutting Wire in Half. Twist or close the connectors as per the kits instructions.

Its very important to disconnect power from already installed landscape lighting. How to Splice Low Voltage Landscape Lighting Wire. How to wire a usb cable and extend splice your usb cable wires In this video I am going to tell you about how to extend USB cable.