How To Splice Outdoor Lighting Wire

Remove the soldering iron and repeat.

How to splice outdoor lighting wire. To extend the low voltage landscape lighting wires you can splice in additional sections of wire. Stretching The Existing Wire of Landscape Lighting. You have to splice the same with the same in order for the lights to work and not short out.

Loose Wire Connections From Excessive Wire Tensions. When youre ready to splice the wires strip about five inches of casing off the ends. Usually its on middle of the wire.

I had planned to splice the wires with wire nuts and then tape those for protection. Cut the wire in the middle with a pair of wire cutters. Start by getting the old landscape lighting disconnected.

A DBR connectors are sold at irrigation or lighting stores grease filled wire nutcap. Twist together the old and new wires to create a continuous length of two-lead wire. The cable is buried except for the one place I dug it up to splice in the outdoor outlet.

If something is being installed under the hood it wouldnt be hard to grab the parking light wire within the headlight harness. Prepare the wire for splicing. Before you use the splice kit you will need to cut the damaged wiring on either side of the break and strip the outer sheathing back about three inches.

Twist the wire nut in place and ensure that the wires are not coming out. The following steps need to be followed to splice the low voltage landscape lighting. Also make sure you keep them at least 5 inch apart from each other.